Energy Savings

Energy is a large cost of doing business. Small factors such as leaks in the system, electronic drain valves, and inefficient motors can all add up to add additional costs which can effect the bottom line. CFM Air Equipment has the products and the knowledge to make energy savings a reality for your compressed air system.

Almig Multi Control 3

The Multi Control is a wall mounted controller operating based on your actual air demand and the network pressure. It is able to run your compressors in the most efficient way based on the flow rate of each unit no matter which brand. The controller itself is equipped with a high speed data interface to communicate with each compressor simultaneously.

We will ensure that your compressed air system will run with maximum efficiency and reliability. This will safe you money with low investment cost. It also helps you protect the environment by reducing the energy consumption of your plant. In addition to that it will help you lower your maintenance cost by balancing the load hours of each compressor.

Cycling Refrigerated Dryers

Cycling refrigerated air dryers automatically cycle the refrigeration compressor on and off in response to inlet load conditions. As the inlet air load is reduced, the refrigeration compressor cycles off, providing you with the ability to reduce energy and costs.

Premium Efficiency Motors

Super-E Motors are designed to conserve energy over extended time periods. These premium efficiency designs are available in both Totally Enclosed Fan Cooled and Open Drip Proof construction. All three phase motors are Inverter Ready per NEMA Standard MG1, Part 31.4.4.2. This means the motors in 230 and 460 volts meet NEMAs corona inception voltage requirements, under this Standard, and can withstand peak voltages of up to 1600 volts. Motors having premium efficiency are also available in single phase designs.

Solenoid Valves

Solenoid valves can be installed so when the equipment is not in use the valve closes shutting down the air flow.

Storage Tanks

Adding additional storage volume can make some compressors run more efficiently

Almig Variable Speed Compressors

The ALMiG variable speed drive regulates flow and pressure by continuously adapting motor speed. No energy is wasted and there is no unnecessary equipment wear.

Soft starts and stops protect your equipment. Reduced start currents result in smaller fuses, cables and energy bills. Controlled stops eliminate the risk of water hammer and other costly damage.

A built-in shaft power monitor and a unique Load Curve Protection function protect your process by immediately detecting any situation that could cause inefficiency or damage. Early warnings and safety stops allow preventive action.

Zero-Loss Drains

Energy efficient since they dont waste any air! Zero-loss drains cant often pay for themselves within weeks.